SIOL-EI8B-USER-M
ii
Powered by
Version 1, May 2022
Table of Contents
ii
6. Installation 24
6.1. Electrical Installation of the Module 24
6.1.1. Connecting sensors and actuators 25
6.1.2. Connecting Ethernet bus 26
6.1.3. Connecting the power supply 27
6.2. Ensuring Tightness (IP67) 28
7. Startup 29
7.1. Loading the EDS les 30
7.2. Adding a module as an EtherNet/IP Device 32
7.3. Productivity Suite Integration Library 37
7.4. Commissioning without EDS 44
7.4.1. Connections, parameters and properties 44
7.4.2. Connection matrix 44
7.4.3. Assemblies 44
7.4.4. Conguration values 46
8.1. Module conguration 49
8.2. RPI conguration 51
8.3. IO-Link conguration 52
9. Operation 53
9.1. LED indication 53
9.1.1. LED assignment to channel and pin 53
9.1.2. LED ashing behavior 53
9.1.3. LED indication for inputs and outputs 54
9.1.4. LED display MS and NS 55
9.1.5. LED indication for LNK/ACT 56
9.1.6. LED indication for State 56
9.1.7. LED indication for POWER US and UA 57
9.1.8. Extended LED indication 58
9.2. Diagnostics 59
9.2.1. Diagnostics structure in the control system 59
9.2.2. Diagnostics in the WebUI 59
9.2.3. Diagnostic value 60
9.2.3.1. Short-circuit diagnostic 60
9.2.3.2. Undervoltage diagnostic 60
9.2.3.3. Overvoltage diagnostic 60
9.2.3.4. General diagnostic 60
9.2.3.5. Buer overow diagnostic 60
9.2.3.6. IO-Link master diagnostic 61
9.2.3.7. IO-Link device diagnostic 62
9.3. Acyclic IO-Link device access 64
To Next Page
Loading...
