During the login process, the IP Deskphone can receive calls for user accounts that are already
registered; however, other features are not available until the login process is complete.
No profile selection prompt is displayed for the secondary account and no profile is created.
Related links
Initial login on page 201
Automatic login
If the automatic login feature is enabled and you were logged in when the IP Deskphone was
switched off, the IP Deskphone automatically logs you back in upon startup. If multiple users were
logged in, then they are all logged back in one after the other.
If the automatic login feature is disabled, then the automatic login does not occur.
It is possible to provision the IP Deskphone with user credentials for automatic login even on the
initial startup. With the addition of multiuser support, it is also possible to provision multiple accounts
in the same way. For more information about different autologin scenarios, see Primary account
logout on page 204.
Related links
Initial login on page 201
Logging out
The logout command prompts you to select an account, asks for confirmation, then proceeds to log
out the account. Logging out an account frees the corresponding Line key. Logging out does not
require a password.
For more information about logging out, see Logging off from the IP Deskphone on page 42
The following figure shows the logout screens.
Figure 46: Logout screens
Related links
Multiuser on page 201
Logging out
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 203
Comments on this document? infodev@avaya.com
To Next Page
Loading...
