Warning:
Your Avaya 1140E IP Deskphone is shipped with the base locked in position. To avoid
damaging your phone, press the wall-mount lever, located under the Handsfree key as
indicated in
Wall-mount lever on page 47, to release the base and pull it away from the IP
Deskphone.
Removing the stand cover
To access the cable routing tracks and attach cables, you must remove the stand cover. Pull upward
on the center catch as indicated in the following figure, and remove the stand cover. The cable
routing tracks are now accessible.
Figure 14: Remove the stand cover
Connecting the AC power adapter (optional)
Your 1140E IP Deskphone supports AC power or Power over Ethernet (PoE) options, including
IEEE 802.3af standard power.
To use local AC power, use only the Avaya-approved Global Power Supply (NTYS17xxE6). You can
order the Avaya-approved AC adapter separately.
Warning:
Use only the approved Avaya AC Adapter with your IP Deskphone.
To use PoE, where power is delivered over the CAT5 cable, your connected LAN must support PoE.
If you use PoE, you do not require an AC adapter.
Installing the 1140E IP Deskphone
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 48
Comments on this document? infodev@avaya.com
To Next Page
Loading...
