In-call context-sensitive soft keys
When a call is active, use the context-sensitive soft keys to access the menu items shown in the
following figure.
Figure 5: In-call context-sensitive soft keys
Table 4: Menu items accessed during an in-call session through context-sensitive soft keys
Item Function
Conf Press the Conf context-sensitive soft key to obtain a dial tone to
place another call during an active call or to make a conference
call.
The Conf context-sensitive soft key behaves like the NewCall
context-sensitive soft key.
Trnsfer Press the Trnsfer context-sensitive soft key to transfer the
current call to another location or to another contact.
Audio Press the Audio soft key to:
1. Change Audio Codec
• G722 (wideband codec)
• PCMU (standard u-law)
• G729 (729 codec)
• PCMA (standard a-law)
2. Monitor Audio Quality — used to view details about the audio
quality of an active call.
Activate The Activate context-sensitive soft key appears when the call is
not active. The most common usage of this key is when the call
displayed onscreen is a call that was parked against the user (or
a call that the user placed on hold).
Note: The Activate context-sensitive soft key never appears at
the same time as the Audio context-sensitive soft key.
Table continues…
Introduction to the Avaya 1140E IP Deskphone
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 26
Comments on this document? infodev@avaya.com
To Next Page
Loading...
