To connect your PC through your IP Deskphone use the following procedure:
1. Connect one end of the PC Ethernet cable to your IP Deskphone using the RJ-45 connector
marked with the network symbol.
2.
Thread the cable through the channel marked with the workstation symbol, as follows:
3. Connect the other end of the cable to the LAN connector on the back of your PC.
Installing additional cables
If applicable, you can plug an optional USB device such as a USB mouse or a USB keyboard into
your IP Deskphone. Connect the USB cable to the USB port on the back of the IP Deskphone.
Wall-mounting the IP Deskphone (optional)
You can mount your Avaya 1140E IP Deskphone on a wall either by: (method A) using the mounting
holes on the bottom of the IP Deskphone stand or (method B) using a traditional-style wall-mount
box with an RJ-45 connector and 15 centimeter (cm) (6-inch) RJ-45 cord (not provided).
Figure 15: Cable routing tracks and mounting holes
Complete these steps, as needed, before you wall-mount your IP Deskphone:
Method A:
1. Press the wall-mount lever, and pull the IP Deskphone away from the stand, as shown in the
figure below.
2. Use the stand cover (the part you removed in Removing the stand cover on page 48), to
mark the wall-mount holes by pressing the bottom of the stand cover firmly against the wall
in the location where you wish to install the IP Deskphone. Four small pins on the bottom of
the stand cover make marks on the wall.
Connecting the components
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 51
Comments on this document? infodev@avaya.com
To Next Page
Loading...
