3. Use the marks as a guideline for installing the wall-mount screws (not provided). Install the
screws so that they protrude 3 millimeters (mm) (1/8 inch) from the wall.
4. Install the IP Deskphone stand mounting holes over the screw heads as indicated in the
figure above (Method A). You need to remove the IP Deskphone from the wall to adjust the
lower screws.
5. When the lower screws are snug, install the IP Deskphone on the mounting screws, and
then tighten the top screws.
Figure 16: Rotate the IP Deskphone into the wall mount position
Method B:
1. Attach the 15-cm (6-inch) CAT5e cable.
2. Position the stand over the mounting rivets, and slide the IP Deskphone down the wall so
that the rivets fit into the slots on the stand, indicated in
Cable routing tracks and mounting
holes on page 51(Method B).
3. Replace the stand cover. Ensure that all cables are neatly routed and press the stand cover
into place until you hear a click.
4. Put the IP Deskphone in the wall-mount position (optional). If you wall-mount your IP
Deskphone, put it in the wall-mount position by holding the Tilt Lever and pressing the IP
Deskphone towards the base until the IP Deskphone is parallel with the base. Release the
Tilt Lever and continue to push the IP Deskphone towards the base until you hear an audible
click. Ensure the IP Deskphone is securely locked in position.
Note:
To add an Expansion Module for Avaya 1100 Series IP Deskphones see Expansion
Module for Avaya 1100 Series IP Deskphones (SIP Software) User Guide
(NN43110-301).
Installing the 1140E IP Deskphone
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 52
Comments on this document? infodev@avaya.com
To Next Page
Loading...
