Avaya 1140E - Interaction with Wired Headsets

Press the Headset key
• If a single tone sounds, the headset is connected to the base.
• If a double beep sounds, the headset is connected to the IP Deskphone.
• If the base is powered off, the headset is only paired to the IP Deskphone, and you can press
the telephone key to connect to the IP Deskphone.
Note:
Unless you need to dual pair a headset, operating the headset with the IP Deskphone is simpler
if the headset is only used with its charging-only base. You should power off the desktop
telephone base, if it is not in use
Interaction with wired headsets
If you connect a Bluetooth wireless technology headset and a wired headset to the same Avaya
1140E IP Deskphone, the two interact as follows:
• If a wireless headset is not paired, the wired headset works as normal. Likewise, if a wireless
headset is paired with a wired headset, but the wireless headset is not in range, the wired
headset works as normal.
• If the Use BT headset checkbox is selected, the wireless headset is used as the IP Deskphone
headset.
The Bluetooth wireless technology headset can work only if it is within range of the IP Deskphone.
As the wireless headset approaches the edge of its wireless range, the audio quality degrades, and
radio interference noise increases. When the wireless headset is in connecting range, the Headset
key controls the wireless headset, even if a wired headset is attached. If a wireless headset moves
out of connecting range, a special beep sounds in the headset to indicate that the connection is lost.
When you do not want to use your Bluetooth technology headset
If a Bluetooth wireless technology headset is connected, and you want to use the wired headset,
you can switch between the two. It is not necessary to unpair or disable the wireless headset.
You can switch between a wired and wireless headset and back again when the IP Deskphone is
idle or during an active call.
To switch between a wired headset and a wireless headset:
1. Double-press the
Headset key to open the Bluetooth Setup
dialog.
2. Press the Left/Right navigation key to select the Use BT
Headset item.
3. Press the Enter key to toggle this option on or off.
A check mark indicates that the wireless headset is used. Clear the
check mark to use a wired headset. This option is on by default.
To unpair a wireless headset:
Configuring the Avaya 1140E IP Deskphone
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 84
Comments on this document? infodev@avaya.com