Figure 20: Headset screen
The following table describes the configuration options on the Headset screen.
Option Function
Active Headset Device Select the active headset device; either USB or Wired.
Note:
The headset can be selected before it is attached (wired or
USB).
Items below the Active Headset Device field are dimmed, if either
USB headset is not selected or if the attached headset is not one
of the Human Interface Device (HID) supported headset types.
Wired Headset Type Select the type of wired headset you required.
• Headset Type 1 (Generic narrow band)
• Headset Type 2 (Wideband)
• Headset Type 3 (Wideband)
Enable HID Commands Enable HID Commands only if USB headset is selected.
The checkbox is used to enable the HID commands of supported
headsets to allow the IP Deskphone to run in generic mode 1
operation, supporting both USB audio and HID commands. The
configuration is ignored for non-supported USB headsets.
MHS Headset Type Choose an MHS Headset Type only if Avaya headset adapter is
detected.
This list contains the different wired headset types that can be
attached to the Avaya Enhanced or Mobile Adapters for loss plan
adjustment. The command is ignored for other types of USB
Table continues…
Configuring the Avaya 1140E IP Deskphone
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 72
Comments on this document? infodev@avaya.com
To Next Page
Loading...
