Disconnecting and reconnecting phone
About this task
Remove the phone and then reconnect it to force a reload of the MAC address in the range
table.
Procedure
1. Follow local procedures to disconnect the phone.
2. Follow local procedures to reconnect the phone.
Disabling and enabling the port
About this task
Disable ADAC on the port and then enable it to detect the phone. After disabling and re-
enabling the port administratively, the MAC addresses already learned on the respective port
are aged out.
Procedure
1. Use the no adac enable <port> command to disable ADAC.
2. Use the adac enable <port> command to enable ADAC.
Reduce LLDP devices
Reduce the number of LLDP devices. More than 16 devices may cause detection issues.
Task flow: Reduce LLDP devices
About this task
The following task flow assists you to reduce the number of LLDP devices on the system.
Troubleshooting ADAC
108 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com
To Next Page
Loading...
