Avaya 4000 Series - Viewing EAPOL settings; Setting EAPOL port administrative status to auto; EAP multihost repeated re-authentication issue

Procedure
1. Use the eapol enable command to enable EAP globally on the Avaya Ethernet
Routing Switch 4000 Series device.
2. Ensure that there are no errors after command execution.
Viewing EAPOL settings
About this task
Review the EAPOL settings to ensure EAP is enabled.
Procedure
1. Use the show eapol port <port#> command to display the information.
2. Observe the output.
Setting EAPOL port administrative status to auto
About this task
Set the EAPOL port administrative status to auto.
Procedure
1. Use the eapol status auto command to change the port status to auto.
2. Ensure that there are no errors after the command execution.
EAP multihost repeated re-authentication issue
Eliminate the multiple authentication of users.
EAP multihost repeated re-authentication issue
Troubleshooting Avaya ERS 4000 Series April 2014 127