Avaya 4000 Series - Enabling RADIUS to authenticate non-EAPOL clients; Formatting non-EAPOL RADIUS password attribute; Displaying EAPOL multihost interface; Enabling RADIUS To Auth non-EAP MACs

Enabling RADIUS to authenticate non-EAPOL clients
About this task
Make the required changes on the RADIUS server to authenticate non-EAP clients.
Apply changes to the RADIUS server using vendor documentation.
Formatting non-EAPOL RADIUS password attribute
About this task
Make the required changes to the password format on the RADIUS server.
The RADIUS server is to have the format changed to IpAddr.MACAddr.PortNumber.
Displaying EAPOL multihost interface
About this task
Review the EAPOL multihost information.
Procedure
1. Enter the show eapol multihost interface <port#> command to display
the information.
2. Verify the following:
• Use RADIUS To Authenticate Non EAP MACs is enabled.
Enabling RADIUS To Auth non-EAP MACs
About this task
Make the required changes on the RADIUS server to authenticate non-EAP clients.
Apply any changes to the RADIUS server using vendor documentation.
RADIUS server configuration error
The RADIUS server requires that the correct MAC address and password for the Avaya
Ethernet Routing Switch 4000 Series device be configured.
Troubleshooting authentication
150 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com