Avaya 4000 Series - Enabling Multicast Packets

Job aid
The following table describes the output of the show vlan igmp unknown-mcast-no-
flood command.
Field Description
Allowed Multicast Addresses Indicates the MAC addresses for which the
multicast traffic is not pruned when the option
igmp unknown-mcast-no-flood is enabled.
Enabling multicast packets
About this task
Use this procedure to enable the multicast flooding.
Procedure
1. Use the unknown-mcast-allow-flood command to enable multicast flooding.
2. Observe the command output.
Multicast packets not flooding network
Troubleshooting Avaya ERS 4000 Series April 2014 207