Avaya 4000 Series - AAUR: configuration for the units in the stack is not saved on the base unit

Procedure
Figure 20: DHCP
AAUR: configuration for the units in the stack is not saved
on the base unit
Use the recovery tree in this section if configuration for the units in the stack is not saved on
the base unit. The typical scenario is that configuration for a unit in a stack is not saved on the
base unit because the AUR Auto-Save is disabled. You can manually save the configuration
of a non–base unit to the base unit regardless of the state of the AUR feature.
AAUR: configuration for the units in the stack is not saved on the base unit
Troubleshooting Avaya ERS 4000 Series April 2014 69