Procedure
1. Obtain network information for the RADIUS server from the Planning and
Engineering documentation.
2. Follow vendor documentation to set the RADIUS authentication method MD5.
Viewing RADIUS information
About this task
Review the RADIUS server settings in the device. The default server port is 1812/UDP. Older
servers may use 1645/UDP, and other older servers do not support UDP at all
Procedure
1. Use the show radius-server command to view the RADIUS server settings.
2. Refer to the vendor documentation for server configuration.
Configuring the RADIUS server settings
About this task
The RADIUS server settings must be correct for the network.
Follow vendor documentation to set the RADIUS server settings.
Reconfiguring the shared secret
About this task
Reset the shared secret in case there was any corruption.
Procedure
1. Use the radius server host key command.
2. Refer to the vendor documentation for server configuration.
Troubleshooting authentication
122 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com
To Next Page
Loading...
