Stack Forced Mode
If you enable the Stack Forced Mode feature and a stack of two units breaks, the standalone
switch that results from that broken stack of two is managed using the previous stack IP
address. Use the recovery tree in this section if you cannot access the standalone switch using
the stack IP address.
You cannot access a switch at the stack IP address using ping,
Telnet, SSH, Web, or DM recovery tree
About this task
If you cannot access a standalone switch in a broken stack of two units, even though you had
enabled the Stack Forced Mode feature, check that the standalone device still has a physical
connection to the network. The following figure shows the recovery tree for this scenario.
Emergency recovery trees
76 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com
To Next Page
Loading...
