Avaya 4000 Series - Selecting the forward path mode

Procedure
1. Enter the ip dhcp-relay fwd-path <interface address> <server
address> enable command to enable the forward path.
2. Ensure that the command completes.
Variable Definitions
Variable Definition
interface address IPv4 address of the interface
server address IPv4 address of the server
Selecting the forward path mode
About this task
Use the procedure in this section to configure the forward path mode.
Procedure
1. Enter the ip dhcp-relay fwd-path <interface address> <server
address> mode [boot | dhcp | boot-dhcp] command to configure the
forward path mode.
2. Ensure that the command completes.
Variable Definitions
Variable
Definition
interface address IPv4 address of the interface
server address IPv4 address of the server
Troubleshooting DHCP/BootP relay
236 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com