Procedure
Figure 11: Corruption of flash
Incorrect PVID
An issue can occur where clients cannot communicate to critical servers after their ports are
incorrectly put in the wrong VLAN. If the server VLAN is defined as a port based VLAN with a
VLAN ID of 3, and the PVID of the port is 2, then loss of communication can occur. This can
be verified by checking that the PVID of the ports match the VLAN setting. One way to avoid
this problem is to set VLAN configuration control to autoPVID.
Emergency recovery trees
56 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com
To Next Page
Loading...
