Avaya 4000 Series - Pinging the RADIUS server; Enable EAP on the PC; Task flow: Enable EAP on the PC

Pinging the RADIUS server
About this task
Ping the RADIUS server to ensure connection exists.
Procedure
1. Use the ping <server IP> command to ensure connection.
2. Observe no packet loss to confirm connection.
Enable EAP on the PC
The PC must have an EAP-enabled device that is correctly configured.
Task flow: Enable EAP on the PC
About this task
The following task flow assists you to ensure the PC network card has EAP enabled.
Procedure
Figure 44: Enable EAP on the PC
EAP client authentication
Troubleshooting Avaya ERS 4000 Series April 2014 123