Avaya 4000 Series - Viewing trap receiver configuration; Configuring SNMPv1 trap receiver; Configuring SNMPv2 trap receiver

2. Observe the command output.
Viewing trap receiver configuration
About this task
Use the procedure in this section to display the trap receiver configuration.
Procedure
1. Use the show snmp-server host command to view the trap receiver
configuration.
2. Observe the command output.
Configuring SNMPv1 trap receiver
About this task
Use the procedure in this section to configure an SNMPv1 trap receiver.
Procedure
1. Use the snmp-server host <IP Address> public command to configure
the SNMPv1 trap receiver.
2. Observe the command output.
Variable Definitions
Variable
Definition
IP address IPv4 address of the server host
Configuring SNMPv2 trap receiver
About this task
Use the procedure in this section to configure an SNMPv2 trap receiver.
No RSTP SNMP traps are received
Troubleshooting Avaya ERS 4000 Series April 2014 213