Avaya 4000 Series - Configure Terminal; Router Isis

Table 1: ACLI command modes
Command mode and
sample prompt
Entrance commands Exit commands
User EXEC
4548GT-PWR>
No entrance command,
default mode
exit
or
logout
Privileged EXEC
4548GT-PWR#
enable exit
or
logout
Global Configuration
4548GT-PWR(config)#
configure terminal mode, enter:
end
or
exit
To exit ACLI completely,
enter:
logout
Interface Configuration
4548GT-PWR(config-
if)#
You can configure the
following interfaces:
• Ethernet
• VLAN
From Global Configuration
mode: To configure a port,
enter: interface
ethernet <port
number>
To configure a VLAN, enter:
interface vlan
<vlan number>
To return to Global
Configuration mode, enter:
Exit
To return to Privileged EXEC
mode, enter:
end
To exit ACLI completely,
enter:
logout
Router Configuration
4548GT-
(configrouter)#
You can configure the
following routers:
• RIP
• OSPF
• VRRP
• ISIS
From Global or Interface
Configuration mode: To
configure RIP, enter
router rip. To configure
OSPF, enter router
ospf. To configure VRRP,
enter router vrrp. To
configure IS-IS, enter
router isis.
To return to Global
Configuration mode, enter
exit. To return to Privileged
EXEC mode, enter end. To
exit ACLI completely, enter
logout.
Application Configuration
4850GT-(config-app)
From Global, Interface or
Router Configuration mode,
enter application.
To return to Global
Configuration mode, enter
exit. To return to Privileged
EXEC mode, enter end. To
exit ACLI completely, enter
logout.
General diagnostic tools
50 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com