Enabling IPv6 interface on management VLAN
About this task
Use this procedure to enable IPv6 on the management VLAN. The operational state becomes
active about 30 seconds from boot, synchronized with the time when the IPv4 configured
address is in use.
Procedure
1. Use the show vlan mgmt command to show the management VLAN.
2. Use the interface vlan <Number> command to configure the management
VLAN.
3. Use the ipv6 interface enable command to enable IPv6 on the management
VLAN.
4. Ensure the admin-status is set to enabled.
Configuring IPv6 address
About this task
Use the procedure in this section to configure an IPv6 address for the device.
Procedure
1. Use the ipv6 address switch <IPv6 address> command to assign an IPv6
address to the switch.
2. Ensure the command completes without error.
Displaying IPv6 global information
About this task
Use the procedure in this section to display IPv6 global information for the device.
Procedure
1. Use the show ipv6 global command to display the IPv6 global information.
Device not responding to ping to its IPv6 address
Troubleshooting Avaya ERS 4000 Series April 2014 171
To Next Page
Loading...
