Procedure
1. Enter the ip route <server.ip.address.class> <netmask>
<next.hop.ip.address> <cost> command to configure the IP route.
2. Observe the command output.
Viewing global relay setting
About this task
Use the procedure in this section to view the global relay configuration.
Procedure
1. Enter the show ip dhcp-relay command to display the global relay
configuration.
2. Observe the command output and confirm DHCP relay is enabled.
Enabling global relay
About this task
Use the procedure in this section to enable DHCP relay globally.
Procedure
1. Enter the ip dhcp-relay command to enable DHCP relay globally.
2. Observe the command output.
Viewing VLAN relay information
About this task
Use the procedure in this section to display the VLAN relay configuration.
Procedure
1. Enter the show vlan dhcp-relay command to display the VLAN relay
configuration.
Troubleshooting DHCP/BootP relay
234 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com
To Next Page
Loading...
