Enabling IP routing on VLAN
About this task
Use the procedure in this section to enable IP routing on a VLAN.
Procedure
1. Enter the interface vlan <VLANID> command to select the VLAN interface to
be modified.
2. Enter the ip routing command to enable IP routing on the interface.
Variable Definitions
Variable Definition
VLANID Unique ID of the VLAN
Viewing IP static routes
About this task
Use the procedure in this section when the server is not connected to the same Ethernet
Routing Switch and configure a client with static IP for connectivity purposes. From that client,
ping the server. If the ICMP echo requests do not reach the server, verify that a route is
configured on the switch for the server.
Procedure
1. Enter the show ip route static command to display the IP static route
information.
2. Observe the command output.
Configuring IP route
About this task
Use the procedure in this section to configure the IP route.
Bootp/DHCP requests from clients do not reach Bootp/DHCP server
Troubleshooting Avaya ERS 4000 Series April 2014 233
To Next Page
Loading...
