Avaya 4000 Series - Reload ADAC MAC in range table; Task flow: Reload ADAC MAC in range table

Procedure
1. Use the vlan ports <port> filter-unregistered-frames disable
command to view the details.
2. Ensure no errors after command execution.
Reload ADAC MAC in range table
Ensure the ADAC MAC address is properly loaded in the range table.
Task flow: Reload ADAC MAC in range table
About this task
The following task flow assists you to place the ADAC MAC address in the range table.
Procedure
Figure 36: Reload ADAC MAC in range table
IP phone is not detected
Troubleshooting Avaya ERS 4000 Series April 2014 107