Avaya 4000 Series - Enabling use of RADIUS assigned VLANs; Showing EAPOL multihost interface; Showing VLAN config control

Enabling use of RADIUS assigned VLANs
About this task
Change the "allow RADIUS assigned VLAN" setting to "enable".
Procedure
1. Use the eapol multihost use-radius-assigned-vlan command to allow
the use of VLAN IDs assigned by RADIUS.
2. Ensure that there are no errors after execution.
Showing EAPOL multihost interface
About this task
Display the EAPOL interface information.
Procedure
1. Use the show eapol multihost interface <port#> command to display
the interface information.
2. Note the status of ALLOW RADIUS VLANs.
Showing VLAN config control
About this task
Display the VLAN config control information.
Procedure
1. Use the show vlan config control command to display information.
2. Identify if the config control is set to strict.
Troubleshooting authentication
138 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com