Configuring another call server and uplink port
About this task
Configuring another call server and uplink port can assist the auto configuration.
Procedure
1. Use the adac uplink-port <port> command to assign the uplink port.
2. Use the adac call-server-port <port> command to assign the call server
port.
Replacing the unit
About this task
Replace the unit to replicate configuration if AUR is enabled.
Procedure
1. Follow the replacement guidelines in Configuring Systems on Avaya Ethernet
Routing Switch 4000 Series, NN47205-500.
2. Refer to the unit replacement section in the Troubleshooting Hardware section of
this document.
Check status and number of devices
Auto configuration can stop being applied after a unit is removed from the stack.
Task flow: Check status and number of devices
About this task
The following task flow assists you to correct the auto configuration.
Auto configuration is not applied
Troubleshooting Avaya ERS 4000 Series April 2014 113
To Next Page
Loading...
