Showing logging
About this task
Use the procedure in this section to display logging information.
Procedure
1. Use the show logging command to display logging information.
2. Look for a message that states that duplicate address detection failed.
Configuring another IPv6 address
About this task
Use the procedure in this section to configure a new IPv6 address.
Procedure
1. Use the IPv6 address <ipv6_address/prefix_length> command to
configure a new IPv6 address.
2. Return to the beginning of the task flow if the issue is not resolved.
Configuring another link-local ID
About this task
Use the procedure in this section to configure a new link-local ID.
Procedure
Use the IPv6 interface link-local <WORD 0-19> command to configure a
new link-local ID.
Cannot ping IPV6 host from device console
When you ping an IPv6 address from the device, the ping fails.
Cannot ping IPV6 host from device console
Troubleshooting Avaya ERS 4000 Series April 2014 173
To Next Page
Loading...
