Avaya 4000 Series - Verifying IP connectivity between server and client

Navigation
•
Verifying IP connectivity between server and client on page 238
Verifying IP connectivity between server and client
Before you begin
• The server is not connected to the same Ethernet Routing Switch.
About this task
Use the procedure in this section to verify the connectivity between the DHCP server and its
client.
Procedure
1. Use the show ip route static command to ensure ICMP requests from the
client reach the server.
2. From the server, ping the client configured with a static IP address.
3. Verify that a route is configured on the server and the route points to the subnet of
the client.
4. Using the server documentation, configure the route if it does not exist.
Troubleshooting DHCP/BootP relay
238 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com