Avaya 4000 Series - Enabling VLAN relay; Viewing forward path settings; Enabling the forward path

2. Observe the command output.
Enabling VLAN relay
About this task
Use the procedure in this section to enable VLAN relay.
Procedure
1. Enter the interface vlan <VLANID> command to select the VLAN interface to
be modified.
2. Enter the ip dhcp-relay command to enable DHCP relay on the interface.
Variable Definitions
Variable Definition
VLANID Unique ID of the VLAN
Viewing forward path settings
About this task
Use the procedure in this section to display the forward path settings.
Procedure
1. Enter the show ip dhcp-relay fwd-path command to display the forward path
configuration.
2. Ensure that the interface is enabled.
Enabling the forward path
About this task
Use the procedure in this section to enable the forward path.
Bootp/DHCP requests from clients do not reach Bootp/DHCP server
Troubleshooting Avaya ERS 4000 Series April 2014 235