Avaya 4000 Series - Viewing IGMP Snoop Settings

Viewing IGMP snoop settings
About this task
Use this procedure to display general information about IGMP snooping in a specific VLAN.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface vlan <vid>
2. Use the show ip igmp interface command to display IGMP interface
information.
3. Use the show ip igmp snooping command to display information about the
IGMP snooping configuration.
4. Observe the displayed information.
Variable Definitions
Variable
Definition
<vid> Specifies the VLAN ID between 1 and
4094.
Job aid
The following table describes the output of the command show ip igmp interface.
Field Description
VLAN Indicates the VLAN on which IGMP is
configured.
Query Intvl Specifies the frequency (in seconds) at
which host query packets are transmitted on
the interface.
Vers Specifies the version of IGMP configured on
this interface.
Multicast packets not flooding network
Troubleshooting Avaya ERS 4000 Series April 2014 203