Avaya 4000 Series - EAP RADIUS VLAN is not being applied; Work flow: EAP RADIUS VLAN is not being applied

2. Use the eapol multihost eap-packet-mode unicast command to set the
EAPOL request packet to unicast for the interface.
EAP RADIUS VLAN is not being applied
Ensure that the RADIUS VLAN is applied correctly to support EAP.
Work flow: EAP RADIUS VLAN is not being applied
About this task
The following work flow assists you to determine the cause and solution of the RADIUS VLAN
not being applied.
Procedure
Figure 50: EAP Radius VLAN is not being applied
Troubleshooting authentication
132 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com