Avaya 4000 Series - Page 131

Procedure
Figure 49: Set EAPOL request packet
Setting EAPOL request packet globally
About this task
Globally change the EAPOL request packet from multicast to unicast.
Procedure
1. Use the eapol multihost eap-packet-mode unicast command to set the
EAPOL request packet to unicast.
2. Ensure that there are no errors after execution.
Setting EAPOL request packet for a port
About this task
Change the EAPOL request packet from multicast to unicast for a specific port.
Procedure
1. Enter the Interface Configuration mode.
EAP multihost repeated re-authentication issue
Troubleshooting Avaya ERS 4000 Series April 2014 131