Avaya 4000 Series - Displaying the EAPOL port; Setting global eap enabled and port at eap-auto; Displaying EAPOL multihost

Displaying the EAPOL port
About this task
Review the EAPOL port information.
Procedure
1. Enter the show eapol port <port#> command to display the information.
2. Ensure that global EAP is enabled and port status is set to eap-auto.
Setting global eap enabled and port at eap-auto
About this task
Make required changes to enable EAP globally and to set the port status to auto.
Procedure
1. Use the eapol enable command to enable EAP globally.
2. Use the eapol status auto command to change port status to auto.
Displaying EAPOL multihost
About this task
Review the EAPOL multihost information.
Procedure
1. Enter the show eapol multihost command to display the information.
2. Note the following:
• Use RADIUS To Authenticate NonEAPOL Clients is enabled.
• Non-EAPOL RADIUS password attribute format is
IpAddr.MACAddr.PortNumber
Non-EAP RADIUS MAC not authenticating
Troubleshooting Avaya ERS 4000 Series April 2014 149