Avaya 4000 Series - Page 115

2. Note if the oper state is disabled and the number of devices connected.
Reducing the number of devices
About this task
Reduce the number of LLDP devices on the system.
Procedure
1. Follow local procedures and Standard Operating Procedures to reduce the number
of devices connected.
2. Use the show adac in <port> command to display the ADAC information for
the port to ensure that less than 32 devices are connected.
Disabling and enabling the port
About this task
Administratively disable and enable the port to initialize the configuration.
Procedure
1. Use the no adac enable <port> command to disable ADAC.
2. Use the adac enable <port> command to enable ADAC.
Auto configuration is not applied
Troubleshooting Avaya ERS 4000 Series April 2014 115