Setting global EAP enabled and port at eap-auto
About this task
Make corrections to ensure that EAP is enabled globally, and that the port EAP status is set
to auto.
Procedure
1. Use the eapol enable command to enable EAP globally.
2. Use the eapol status auto command to change port status to auto.
Showing EAPOL multihost
About this task
Display the EAPOL multihost information.
Procedure
1. Enter the show eapol multihost command to display the information.
2. Ensure that Allow Non-EAPOL clients is enabled.
Enabling allow non-EAPOL clients
About this task
Correct the non-EAPOL client attribute.
Procedure
1. Use the eapol multihost allow-non-eap-enable command to allow non-
EAPOL clients.
2. Ensure that there are no errors after execution.
Showing EAPOL multihost interface
About this task
Display the EAPOL multihost interface information.
Troubleshooting authentication
144 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com
To Next Page
Loading...
