Avaya 4000 Series - Showing EAP-non-EAP clients on port; Showing EAPOL port information; Making changes

Showing EAP–non-EAP clients on port
About this task
Display EAP–non-EAP client information on the port to provide additional information.
Procedure
1. Use the show mac-address-table command to show the clients on the port.
2. Observe the log output and note anomalies.
Showing EAPOL port information
About this task
Display EAPOL port information for additional information.
Procedure
1. Use the show eapol port <port#> command to display the port information.
2. Observe the log output and note anomalies.
Making changes
About this task
This section provides troubleshooting guidelines for changing the EAP settings. It assists in
the cleanup of old MAC addresses.
Procedure
1. Use the eap status unauthorized command to set the administrative state of
the port to forced unauthorized.
2. Use the eapol status auto command to change to eap-auto.
3. In the Interface Configuration Mode, use the shut/no shut commands.
Troubleshooting authentication
158 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com