5. Display the PoE+ main status. Check that PD Detect type is 802.3at or 802.3at and
Legacy:
show poe-main-status
6. Check the PoE port status. It should deliver power. Note the PoE classification for
the endpoint device detected on the port, and the power limit set for the port:
show poe-port-status [<portlist>]
7. Display the port PoE power measurement:
show poe-power-measurement
Example
(config)#sho lldp port 7 tx-tlv dot3
-------------------------------------------------------------------------------
LLDP port dot3 tlvs
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Port MacPhy MdiPower Link MaxFrameSize
ConfigStatus Support Aggregation
-------------------------------------------------------------------------------
7 false true false false
-------------------------------------------------------------------------------
(config)#sho lldp port 7 tx-tlv dot3
-------------------------------------------------------------------------------
LLDP port dot3 tlvs
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Port MacPhy MdiPower Link MaxFrameSize
ConfigStatus Support Aggregation
-------------------------------------------------------------------------------
7 false true false false
-------------------------------------------------------------------------------
(config)#sho lldp port 7 local-sys-data dot3
-------------------------------------------------------------------------------
LLDP local-sys-data chassis
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
ChassisId: MAC address 84:83:71:0a:f8:00
SysName:
SysCap: rB / B (Supported/Enabled)
SysDescr:
Ethernet Routing Switch 4826GTS-PWR+ HW:10 FW:5.6.2.1 SW:v5.7.0.114
-------------------------------------------------------------------------------
LLDP local-sys-data port
-------------------------------------------------------------------------------
Port: 7
Dot3-MAC/PHY Auto-neg: supported/enabled OperMAUtype: 1000BaseTFD
PSE MDI power: supported/enabled Port class: PSE
PSE power pair: signal/not controllable Power class: 0
PSE: Type: Type 2 PSE Source: Primary Priority: Low
PSE: PD requested power: 23.0 Watts
PSE: PSE allocated power: 23.0 Watts
LinkAggr: not aggregatable/not aggregated AggrPortID: 0
MaxFrameSize: 9216
PMD auto-neg: 10Base(T, TFD), 100Base(TX, TXFD), (FdxA)Pause,
1000Base(TFD)
-------------------------------------------------------------------------------
Troubleshooting authentication
162 Troubleshooting Avaya ERS 4000 Series April 2014
Comments? infodev@avaya.com
To Next Page
Loading...
