Parameter name Default
value
Description
DHCPSTAT 3 Specifies whether DHCPv4,
DHCPv6 or both are used if IPv6
support is enabled by IPV6STAT.
Note:
DHCPv4 is always enabled in
IPv4 only and dual mode.
DHCPv4 is disabled in IPv6
only mode.
Value operation:
• 1: run DHCPv4 only.
• 2: run DHCPv6 only.
• 3: run both DHCPv4 and DHCPv6.
DHCPSTD 0 Specifies whether DHCP complies
with the IETF RFC 2131 standard
and continues to use the expired
DHCP lease.
Value operation:
• 0: Continue using the address in
an extended rebinding state.
• 1: Immediately stop using the
address.
DHCPSTDV6 0 Specifies whether DHCPv6 will
comply with the IETF RFC 8415
standard and immediately stop
using an IPv6 address if the address
valid lifetime expires, or whether it
will enter an extended rebinding
state.
Value operation:
• 0: DHCPv6 enters proprietary
extended rebinding state (continue
to use IPv6 address, if DHCPv6
lease expires).
• 1: DHCPv6 complies with IETF
RFC 8415 standard (immediately
release IPv6 address, if DHCPv6
lease expires).
Table continues…
January 2020 Installing and Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP
Deskphones SIP 173
Comments on this document? infodev@avaya.com
To Next Page
Loading...
