Note:
The SIG value "Default" can represent either SIP or H.323 depending on the upgrade
file used for the deskphone.
3. To change the setting, press the Change softkey until you see the setting you want or use
the Right or Left navigation arrow to cycle through the settings.
Depending on the current value, the next sequential text string is selected and displayed
as the setting. For example, if the current value is SIP (2), pressing the Right arrow
changes the value to 0 (default). If the current value is H.323 (1), pressing Right arrow
changes the value to 2 (SIP).
4. Press Save to store the new setting and redisplay the Administration procedures screen.
The remainder of this procedure depends on the status of the boot and application files.
Configuring SIP settings
About this task
Use this procedure to set up SIP-related settings, such as identifying the SIP proxy server.
Procedure
1. Select SIP from the Administration procedures screen.
The phone displays the following:
• SIP Global Settings
• SIP Proxy Server
2. Press Select or OK or the corresponding line button to change any of the following SIP
global settings:
• SIP Domain: Changes the domain parameter of SIP.
• Avaya Environment: Specifies whether the available SIP Avaya environment is in
effect.
The two modes to detect the available environment are as follows:
- Auto: Detects the Avaya environment automatically.
- No: Does not detect the Avaya environment and switches to a non-Aura mode.
• Reg Policy: Specifies the registration policy for SIP.
The two modes are as follows:
- alternate: Supports registration to one of the active controllers.
- simultaneous: Supports registration to more than one active controllers.
Phone administration
January 2020 Installing and Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP
Deskphones SIP 58
Comments on this document? infodev@avaya.com
To Next Page
Loading...
