Parameter name Default
value
Description
DOT1X 0 Specifies the 802.1X pass-through
operating mode.
Pass-through is the forwarding of
EAPOL frames between the phone's
ethernet line interface and its
secondary (PC) ethernet interface
Value operation:
• 0: EAPOL multicast pass-through
enabled without proxy logoff.
• 1: EAPOL multicast pass-through
enabled with proxy logoff.
• 2: EAPOL multicast pass-through
disabled.
DOT1XEAPS MD5 Specifies the authentication method
to be used by 802.1X.
Valid values are MD5, and TLS.
DOT1XSTAT 0 Specifies the 802.1X supplicant
operating mode.
Value operation:
• 0: Supplicant disabled.
• 1: Supplicant enabled, but
responds only to received unicast
EAPOL messages.
• 2: Supplicant enabled; responds
to received unicast and multicast
EAPOL messages.
DSCPAUD 46 Specifies the layer 3 Differentiated
Services (DiffServ) Code Point for
audio frames generated by the
phone.
Valid values are from 0 to 63.
This parameter can also be set
through the LLDP, which overwrites
any value in the settings file.
DSCPAUD_FL 43 Specifies the DSCP value for flash
precedence or priority level voice
call.
Valid values are from 0 to 63.
Table continues…
January 2020 Installing and Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP
Deskphones SIP 181
Comments on this document? infodev@avaya.com
To Next Page
Loading...
