Avaya CS 1000 Maintenance

Monitor system DTI operation
Maintenance messages
The 2.0 Mb DTI status and error conditions are reported in the types of messages, shown in
Table 61: Maintenance messages on page 131. Additional information on DTI messages is
found in the Avaya Software Input Output Reference - System Messages (NN43001-712).
Table 61: Maintenance messages
Message Meaning
DTA Digital Trunk Alarms (Resident Monitor)
DTI Digital Trunk Interface
2.0 Mb DTI error messages
The Digital
Trunk Interface diagnostic program (LD 60) is used to maintain the NTAK10 2.0 Mb
DTI Interface Card.
Comprehensive lists of the self-test failure codes for the NTAK10 2.0 Mb DTI follow the self-
test description, which starts on
2.0 Mb DTI tests on page 137
.
Grade-of-service messages
Grade-of-Service messages (DT
A XXX) provide near-end and far-end switch status. A
summary of these status messages is given in
Table 62: Grade-of-service messages on
page
131.
Table 62: Grade-of-service messages
Status 2.0 Mb DTI capability
Acceptable Both incoming and outgoing calls allowed
Maintenance Both incoming and outgoing calls allowed
No new data calls No new outgoing data calls
No new calls No new outgoing data or voice calls
Out of Service 2.0 Mb DTI is disabled
Monitor system DTI operation
ISDN Primary Rate Interface Maintenance November 2011 131

Avaya CS 1000 Specifications

General

Brand	Avaya
Model	CS 1000
Category	Server
Language	English