TMDI maintenance commands
The Maintenance Overlays for the
TMDI card have been enhanced. LD 60 is no longer used
for TMDI card and loop maintenance. Only LD 96 is used to handle enabling and disabling of
TMDI cards and their associated loop. Following are the descriptions of LD 96 command
enhancements for TMDI:
Table 45: TMDI maintenance commands
Command Description
DIS TMDI x Disable TMDI card x.
DIS TMDI x ALL Disables the TMDI card and various applications on
the
TMDI. If a DCH is configured on the TMDI, the
DCH is released and the DCH application is disabled.
The TMDI associated loop is also disabled. Active
calls are force disconnected. All channels are
disabled.
ENL TMDI x (FDL) Enable TMDI card x and force a download. This
command only works if TMDI is disabled (loop also
disabled). It attempts to force download all required
applications to TMDI card and then re-enable the card.
When download is completed without error, ENL TMDI
x ALL or ENLL x in Overlay 60 is required to re-enable
the TMDI L1 application and the loop. Under normal
conditions, option FDL to force download f/w to the
TMDI card is not required. If the TMDI card does not
have the latest f/w, the f/w is automatically
downloaded after ENLTMDI x command is enabled.
Force download f/w to the TMDI is only required if a
new PSDL file is created for TMDI f/w. Once the f/w is
downloaded, it burns into the flash on the card. If this
card is disabled and re-enabled again, force download
to the card is not necessary.
ENL TMDI x ALL Enable the TMDI card and various applications on the
card. Also enables the associated loop. If a DCH is
configured on the TMDI, a background audit enables
and establishes the DCH, once the loop is up. DCH
layer 3 should be established within about 30
seconds.
RST TMDI x Reset TMDI card x.
SLFT TMDI x Invoke self-test on TMDI card x.
STAT TMDI (x FULL) Get TMDI status.
1.5 Mb DTI/PRI maintenance
106 ISDN Primary Rate Interface Maintenance November 2011
Comments? infodev@avaya.com
To Next Page
Loading...
Need help?
General
