Command Action
RST DCH N Reset D-channel N.
STAT DCH (N) Print D-channel status (link status).
STAT MSGI (N) Print incoming message monitor status.
STAT MSGO (N) Print outgoing message monitor status.
TEST-100/101/200/201 See DCH tests in technical document.
STAT SERV Print the current service and service acknowledge
message for DCHI N.
ENL SERV N Enable service messages for DCHI N.
DIS SERV N Disable service messages for DCHI N.
Table 44: Downloadable D-channel (DDCH) commands (LD 96)
Command Action
DIS MSDL X (ALL) Disable DCHI card X.
ENL MSDL X (FDL, ALL) Enable DCHI card X, with or without Force
Download.
RST MSDL X Reset MSDL card X.
STAT MSDL X (X (full)) Get MSDL status X, or a "FULL STATUS".
SLFT MSDL X Execute a self-test on MSDL card X.
DIS LLB X Disable local loop back on MSDL DCH X.
DIS RLB X Disable remote loop back on MSDL DCH X.
DIS TEST X Disable Test mode on MSDL DCH X.
ENL LLB X Enable local loop on MSDL DCH X.
ENL RLB X Enable remote loop on MSDL DCH X.
ENL TEST X Enable Test mode on MSDL DCH X.
PCON DCH X Print configuration parameters on MSDL DCH X.
PMES DCH X Print incoming layer 3 messages on MSDL DCH X.
PTRF DCH X Print traffic report on MSDL DCHX.
TEST LLB X Start local loop back test on MSDL DCH X.
TEST RLB X Start remote loop back test on MSDL DCH X.
Note:
"X" represents the D-channel device number.
DTI/PRI maintenance tools
ISDN Primary Rate Interface Maintenance November 2011 105
To Next Page
Loading...
Need help?
General
