Avaya CS 1000 - Clock Controller Commands; 2.0 Mb DTI Tests

Table 65: LD 60 - DTI commands
Command Action
DLBK L Disable loopback mode for 2.0 Mb DTI.
RLBK L Enable loopback mode for 2.0 Mb DTI.
DISI L Disable 2.0 Mb DTI when idle.
DISL L Force disable 2.0 Mb DTI.
ENLL L Enable 2.0 Mb DTI.
LCNT (L) List alarm counters.
RCNT (L) Reset alarm counters.
SLFT (L) Do 2.0 Mb DTI self-test.
STAT (L) List 2.0 Mb DTI status.
Clock controller commands
Below is a quick reference list of clock controller commands in LD 60.
T
able 66: LD 60 - Clock controller commands
Command Action
DIS CC 0 Disable clock controller N.
ENL CC 0 Enable clock controller N.
SSCK 0 Status of clock controller N.
TRCK XXX Set clock controller tracking. XXX can be:
- PCK = track primary clock - SCLK = track secondary clock - FRUN =
free run mode
T
rack primary clock (PCK) or secondary clock (SCLK) as the reference
clock or go to free run (FRUN) mode.
PCK Track primary clock reference source.
SCLK Track secondary clock reference source.
FRUN Free run mode.
2.0 Mb DTI tests
The NT
AK10 self-tests when requested in LD 60. This procedure checks the sanity of the on-
board processors, operation of memory, peripheral hardware, and per-channel as well as per-
loop loopback.
System DTI maintenance tools
ISDN Primary Rate Interface Maintenance November 2011 137