135 = A request for outpulsing was received, but outpulsing data was not
downloaded.
137 = A request for PPM counting was received, but the was not
downloaded.
138 = A MESSOUT 30 was received requesting a task to be performed
for DTI
TS 16 which is not allowed.
DTI009C ch DTI009 error codes for CI microprocessor (M=C):
139 = The 8031 on CHIP RAM failed self-test.
140 = The TS 16 signaling RAM and/or the TS 16 pick up buffer failed
self-test.
141 = The CI-1 micro external RAM failed self-test.
142 = Attempt was made to set/clear the flag used to invoke PPM pulse
timing for DTI timeslot 0 or 16.
143 = CI-2 micro responded to echo request message but response was
in error.
144 = CI-2 micro failed to respond to request echo message.
145 = The request for self-test received did not have the TN of TS 0.
146 = The TN of MESSOUT 26 received was not that or TS 0.
147 = The TN of MESSOUT 28 received was not that of TS 0.
148 = The TN of MESSOUT 29 received was not that of TS 0.
149 = Upon enabling the DTI card, the CI-1 was unable to write Frame
0, TS 16 with '0B'.
150 = MESSOUT 26 was received with the PPM counting bit (abcd) all
equal to zero.
151 = MESSOUT 28 was received with the outpulsing bit (abcd) equal to
zero.
152 = CI-2 failed to respond to the CI-1 watch dog message.
153 = The CI-2 failed to respond to five consecutive watchdog messages
and is assumed to be out of service.
154 = MESSOUT received requesting the lower nibble of MFAS pattern
to be written with something other than '0000'.
155 = MESSOUT received requesting '0000' to be written into an 'abcd'
state.
156 = MESSOUT received with a TN outside the range shelf 0, card 8-1,
unit 3-0.
DTI009C ch DTI009 error codes for CI microprocessor (M=C):
2.0 Mb DTI maintenance
140 ISDN Primary Rate Interface Maintenance November 2011
Comments? infodev@avaya.com
To Next Page
Loading...
