Testing DCHI software
1. Log in to the overlay system. Then, enter overlay program 96 by entering the
command
LD 96
2. If the DCHI link is disabled, it must be enabled by entering the commands
STAT DCH N (responds DSBL
ENL DCH N(if a problem caused the disabled state, RLS will occur; if the disabled
state is cleared, status will be EST)
RST DCH N
3. Place the DCHI link in the reset state (from either the established or Released state)
by entering the commands
STAT DCH N (responds either EST or RLS)
RST DCH N
4. Activate the first software test by entering the command
TEST 200 N
5. Activate the second software test by entering the command
TEST 201 N
DCH tests
ISDN Primary Rate Interface Maintenance November 2011 63
To Next Page
Loading...
Need help?
General
