Avaya J129 - Page 101

Name Description
Privacy SLAAC Mode Specifies the preference for Privacy Extensions in SLAAC.
The options are:
• Disabled, stable address generated from MAC
• Stable private address (default)
• Temporary address
SLAAC Addresses SLAAC (stateless auto configuration) IPv6 addresses.
Value format: eight groups of four hexadecimal digits. The default value
is null.
802.1X Supplicant Operating Mode
Supplicant Operating Mode Specifies the 802.1X supplicant operating mode.
The options are:
• Disable (default)
• Enable (responds only to unicast EAPOL messages)
• Enable (responds to unicast and multicast EAPOL messages)
802.1x Pass-through
Operating Mode
Specifies the 802.1X pass-through operating mode.
Pass-through refers to the forwarding of EAPOL frames between the
phone's Ethernet line interface and the secondary PC Ethernet
interface.
The options are:
• Without proxy logoff (default)
• With proxy logoff
• Disabled
Authentication Method Specifies the authentication method to be used by 802.1X.
The options are:
• MD5 (default)
• TLS
VLAN
VLAN Specifies whether the VLAN tagging is enabled or disabled.
The options are:
• Auto (default): To support VLAN functionality by using the phone
network.
• On: To support the VLAN functionality by using the internal switch of
the phone.
• Off: To disable the VLAN functionality of the phone.
Table continues…
Phone configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 101
Comments on this document? infodev@avaya.com