Avaya J129 - Page 311

Parameter name Default
value
Description
TEAM_BUTTON_REDIRECT_INDICATION 0 Specifies if the redirection
indication must be shown on a
team button on the monitored
station, if it is not a redirect
destination of the monitored station.
Value operation:
• 0: Disabled. The redirect
indication is shown only on a
monitoring station which is
redirection destination.
• 1: Enabled. The redirection
indication is displayed on all
monitoring stations.
Note:
Avaya J139 IP Phone does not
support this feature.
TEAM_BUTTON_RING_TYPE 1 Specifies the alerting pattern to use
for team buttons.
Valid values are 1 through 8. The
default value is 1.
Note:
Avaya J139 IP Phone does not
support Team Button feature.
TIMEFORMAT Specifies the format for time
displayed in the phone.
The TIMEFORMAT parameter is
used when the phone fails to get
time format from the PPM.
Value operation:
• 0: AM or PM format.
• 1: 24 hour format
Table continues…
List of configuration parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 311
Comments on this document? infodev@avaya.com