8-17
■ Setting cycle items
(1) In the set value display state, move to the cycle item to be set for the segment
on the programming map.
(A cycle item is a program setting and is the same for each segment.)
(2) Press the ENTER key to make display panel 2 flash (registration of first
setting).
(3) Use the , , , and keys to make the first setting – setting the cycle
value.
Setting range: 0 to 10000
(4) Press the ENTER key to stop the flashing on display panel 2.
(Pressing the FUNC and CLR keys causes display panel 2 to return to unset
state “0 ” and the flashing stops.)
● Display
•A cycle item is a program setting and is the same for each segment.
• When setup data C60 is set to 1, a cycle item on the programming map is
skipped and not displayed.
NOTE
A cycle item setting does not use subfunctions.
To Next Page
Loading...
