Azbil dcp551 mark II - Program run mode displays

6-3
■ Program run mode displays
● DISP key function
The DISP key is used to cycle through the displays in the following order: Display
A1, display A2, display A3, display A4, displayA 5, display A6, display A1.
● Display A1
When the programmer function is used in MANUAL mode, the number of digits
available for SP recording flashes.
● Display A2
● Display A3
When the controller function is used in MANUAL mode, the number of digits
available for output values flashes.
OUT
PV
PROG SEG
PROFILE
Program
number
Segment
number
PV
Output value (%)
Pattern trend
DEV
PROG SEG
PROFILE
Program
number
Segment
number
PV
Deviation
Pattern trend
PV
PV
SP
PROG SEG
PROFILE
Program
number
Segment
number
PV
SP
Pattern trend
Chapter 6. OPERATION